Your Cart
View Cart

BB60a

Forums › General Discussions › BB60a

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 19, 2014 at 11:50 pm #9058
    terd
    Participant

    Very good Very Fast Spectrum analyzer
    and i Want to monitor their numbers frequently at all vertical lines And want to adjust the to a flat noise floor. Do not want to see the noise floor, swing up and down then full span.

    Attachments:
    You must be logged in to view attached files.
    November 20, 2014 at 9:30 am #9092
    AndrewAndrew
    Moderator

    Hello and thank you for the kind words. Unfortunately, the BB60A does not have a flat noise floor, and there is no way to flatten it without ruining your measurements. This is one of the limitations of the BB60A. If you want to monitor multiple frequencies at once, the software allows you to place up to 6 markers on the screen.

    Regards,
    A.J.

    November 20, 2014 at 4:58 pm #9116
    terd
    Participant

    I know how to adjust the noise floor of the hardware is difficult, but if the read noise floor, then it is probably easier to compensate for the display.

    Marker ok, but not have Peak search Tracking

    Nothing is impossible Tomorrow is better than today.
    Philosophy beat competitors.

    • This reply was modified 11 years, 10 months ago by terd.
    November 23, 2014 at 6:52 am #9304
    terd
    Participant

    Font copper tape, Shield EMI from inside spectrum

    • This reply was modified 11 years, 10 months ago by terd.
    Attachments:
    You must be logged in to view attached files.
  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.